A read only forum where you can see announcements of new products, special sales, and member only specials from CandCNC and other forum vendors. Any announcement or deal must be submitted to the forum Admin for acceptance. The number, scope and duration of any post will be limited. It is suggested that members subscribe to this forum so new posts will be sent to their e-mail address. We HATE spam so this forum will not be abused.
Closed Forum no Posts allowed. Read only access
- Posts: 480
- Joined: Sun Sep 29, 2013 4:25 pm
- Location: Texas
We have just released CommandCNC version 1.0
See the downloads page here: https://www.candcnc.com/downloads/
*** Please read the Release Notes
The biggest feature of this release is support for our new and upcoming EBOB motion card.
Some of the new features with the EBOB are:
- Up to 8 motors. CommandCNC currently supports only 6 axes but more can be added. If you were to use all 6 axes and one was a gantry with 2 motors, you would use 7 motors.
- 12 Outputs in addition to a couple used only for the DTHC.
- 16 isolated inputs.
There are also miscellaneous improvements to the Configurator and there is now initial support for multiple languages (translations not yet complete).
Users browsing this forum: No registered users and 2 guests